CCNA Questions

Fiber-optic cable provides a more secure, long - distance cable that is not susceptible to EMI interference at high speeds.

PPP is your only option because HDLC and Frame RElay do not support these types of business requirements. PPP provides dynamic addressing , authentication using PAP or CHAP, and callback services.

The following are the different types of VPNs :

PPTP ( Point to Point Tunnel protocol ) VPN : Most commonly used VPN. PPTP is a method for implementing virtual private networks. PPTP uses a control channel over TCP and a GRE tunnel operating to encapsulate PPP packets.

Site-to-Site VPN : Site-to-site VPN is a type of VPN connection that is created between two separate locations. Site-to-site VPN can be intranet based or extranet based. 

Intranet-based site-to-site VPN is created between an organization's propriety networks, while extranet-based site-to-site VPN is used for connecting with external partner networks or an intranet.

L2TP ( Layer Two Tunneling Protoco) VPN : L2TP is an extension of the Point-to-Point Tunneling Protocol (PPTP) used by an Internet service provider (ISP) to enable the operation of a virtual private network over the Internet.

IPsec (Internet Protocol Security) : IPsec is a framework for a set of protocols for security at the network or packet processing layer of network communication.

SSL (Secure Sockets Layer) VPN : SSL  is a form of VPN that can be used with a standard Web browser. In contrast to the traditional Internet Protocol Security (IPsec) VPN, an SSL VPN does not require the installation of specialized client software on the end user's computer. 

MPLS (Multiprotocol Label Switching) VPN : MPLS is a protocol for speeding up and shaping network traffic flows. 

Hybrid VPN : A hybrid VPN combines Multiprotocol Label Switching (MPLS) and Internet protocol security (IPsec)-based VPNs. 

The extended access list ranges are 100 - 199 and 2000 - 2699, so the access-list number of 100 is valid. Telnet uses TCP, so the protocol TCP is valid. Now you just need to look for the source and destination address. only the third option has the correct sequence of parameters. Option B may work, but the question specifically states "only" to network 192.168.10.0, and the wildcard in option B is too broad.

To keep open one or more Telnet sessions, use the Ctrl+Shift+6 and then X keystroke combination.

An inside global address is considered to be the IP address of the host on the private network after translation.

Answer : A  D

Explanation:

A and D are correct because successor route is the best and primary route to a remote network. A successor route is used by EIGRP to forward traffic to a destination and is stored in the routing table. Its backed up by a feasible successor route in case the primary route fails, that is stored in the topology table.

B is incorrect because neighbor table only contains a list of directly connected EIGRP routers that have an adjacency with this router, it doesn't contain successor routes.

C is incorrect because successor routes found in the routing table are not flagged as "active”

The IEEE 802.11b standard provides three non-overlapping channels.