Technical Questions

An interpreter reads one instruction at a time and carries out the actions implied by that instruction. It does not perform any translation. But a compiler translates the entire instructions

Both 2 and 3 are clearly the diadvantages of circular list

Hubs are specified or operate at Layer1 i.e, the physical layer in the OSI model. Hubs regenerate electrical signals. A hub sends data packets (frames) to all devices on a network, regardless of any MAC addresses contained in the data packet.

Three Logic Levels are used and they are High, Low, HIgh impedance state. The high and low are normal logic levels & high impedance state is electrical open circuit conditions. Tri-state logic has a third line called enable line.

IPV4 Internet Protocol Version 4 has 32 bits of address.

There are three types of buses.

Address bus: This is used to carry the Address to the memory to fetch either Instruction or Data.

Data bus: This is used to carry the Data from the memory.

Control bus: This is used to carry the Control signals like RD/WR, Select etc.

One of two sublayers of the data link layer of OSI reference model, as defined by the IEEE 802 standard. This sublayer is responsible for maintaining the link between computers when they are sending data across the physical network connection

typedef struct node * treeptr

typedef struct node

{

         int data1;

         float data2;

         treeptr *left;

         treeptr *right;

}treenode;

treeptr ptr;

ptr = ( treeptr ) malloc ( sizeof ( treenode ) );